Transmission sprocket

Having been more than twenty years in the market , we continue to improve our products/quality and services as one of the market leaders today.
Why Ever-power?
Carburized Bushing
Carburizing process increases area hardness and wear level of resistance, while the core remains challenging and ductile.
Shot Peening to all or any Components
All Omega’s conveyor chain parts are very well shot peened, to be able to increase component life.
Ultimate Material Specification
New materials specification with better strength in chain breaking load, yet is still the most cost-effective decision.
Professional Technical and Product Support
Supported by experienced group and official branches in strategic places throughout China
Transmission Sprocket Installation
1. Install the transmission sprocket (with belt) on the key drive gear. 2. Install the sprocket nut. The next procedure is founded on whether a fresh or used nut has been installed. Note: The Transmission Sprocket nut has remaining handed threads. Convert the nut counterclockwise to set up on the key drive gear. Sprocket Nut: apply red thread lock to the threads of the sprocket nut. As well smear a small level of reddish thread lock or clean engine essential oil inside face of the sprocket nut and the exterior deal with of the sprocket. Limit the application to where the surfaces of the two parts contact each other. Install the sprocket nut until finger tight. 3. Obtain Final Drive Sprocket Locking Application (BAKER P/N: Tool-C) to lock transmitting sprocket. Proceed as follows: A. Insert manage of instrument below pivot shaft inboard of bottom frame tube and attach to sprocket. B. Snug thumbscrew to lock placement of software on sprocket. 4. Obtain Mainshaft Locknut Wrench/Pilot (BAKER P/N: Tool-D). Proceed as follows: A. Install pilot on threaded end of mainshaft. B. Slide sleeve of locknut wrench over pilot and onto sprocket nut. C. Tighten sprocket nut to 60 ft-lbs. (81 Nm). As the nut is normally tightened the cope with of the sprocket locking instrument rises to contact the pivot shaft, thus stopping sprocket/mainshaft rotation. 5. Scribe a straight collection on the tranny sprocket nut ongoing the range over onto the tranny sprocket. Tighten the transmission sprocket nut an additional 35 to 40 degrees. 6. Install lockplate over nut in order that the two diagonally contrary holes align with two tapped holes in sprocket. To find the best suit, lockplate can be rotated to several positions and can be positioned with either aspect facing sprocket. 7. If holes in lockplate do not align with those in sprocket, tighten sprocket nut as required (up to 45 degrees maximum) until sprocket and lockplate holes will be in alignment.

V-FACTOR
24 Tooth Sprocket Kit
Fits Big Twin 4 speed with rear disc

Tags:

gearboxworm

As one of leading gearboxworm manufacturers, suppliers and exporters of mechanical products, We offer gearboxworm and many other products.

Please contact us for details.

Manufacturer supplier exporter of gearboxworm

Recent Posts